INVEBI · Interior · Wood · Frames · D12/000AZ
Nitro Clear Glossy Top Coat High Solid
01. Prepare the substrate so it is clean, dry, sound and suitable for the coating system.
02. Mix the product thoroughly and prepare it according to the manufacturer’s technical data.
03. Apply the product with the recommended tool and at the specified dilution/application rate.
04. Observe the required drying and recoating interval before the next coat.
05. Apply additional coats or create the finish according to the selected system and desired effect.
06. Allow the coating to dry and cure fully before putting the surface into service.
APPLICATION
Application instructions
The information is based on data confirmed in the relevant INVEBI technical sheet and stock documentation.
01. Prepare the surface so it is clean, dry and compatible with the product system.
02. Prepare the substrate so it is clean, dry, sound and suitable for the coating system.
03. Mixing / dilution: D12/000AZ 100 + 105/AZ Nitro thinner 30.
04. Prepare the substrate so it is clean, dry, sound and suitable for the coating system.
05. Prepare the substrate so it is clean, dry, sound and suitable for the coating system.
06. Allow the surface to dry fully before recoating or putting it into service.
